MARCUS HOLCOMB

Remove the latch and drill pilot holes through each screw hole mark. Drill the hinge holes with the bit, and screw in the hinge bolts. Drill the hinge holes with the bit, and screw in the hinge bolts. Draw circles inside the screw holes of the hinge strap with a pencil.

Draw circles inside the screw holes of the hinge strap with a pencil. Press the vertical hinge leafs flat against the gate post and draw circles inside the screw holes with the pencil. Press the vertical hinge leafs flat against the gate post and draw circles inside the screw holes with the pencil. Place a mounting screw from the kit flat against one of the hinge holes located on the gate. Place a mounting screw from the kit flat against one of the hinge holes located on the gate. Select a hinge that has screw holes on both sides, such as a strap hinge. Select a hinge that has screw holes on both sides, such as a strap hinge. Align the hinge with the upper line and lay out the hinge's screw holes along the line. Align the hinge with the upper line and lay out the hinge's screw holes along the line.

Place a square on the plumb line and align the square's corner with the lower hinge mark. Align the tape measure's tip with the lower hinge mark. Stretch the tape measure along the plumb line and mark the vertical position of the upper hinge with a pencil. Draw a pencil along the edge of the level, beginning at the lower hinge mark. Mark on the wall with a pencil where the screw holes are located on the wall plate. Mark the positions of the screw holes in the base plate. Using a sharp pencil, draw points where the screw holes are. Using a drill and driving bit, screw the component to the gate, using screws provided in the latch kit. Reposition the latch assembly, screw it to the gate and remove the tape.

The Stanley Max gate latch is a self-adjusting gravity gate latch. Like common gravity latches, the Max gate latch automatically engages when the gate is shut. Installing a gravity gate latch assembly on a wooden gate takes only minutes and requires no special tools. Installing a latch walk gate set only takes a few minutes and provides an instant update for your fence. A latch walk gate set is a simple way to update a boring or dull gate. Open the gate fully and set a galvanized gate latch against the gate and the other side of the fence. Move to the hinge side of the fence and close the gate. Open each hinge and press flat against the fence or gate post. Mount the gate to the hinge post after the post concrete has been setting up for 36-48 hours.

Consider bracing the hinge post to another post if possible. Dig the post hole and set this post just as the hinge end post was done. Set one of the mounting screws against one of the holes in the anchor and screw it into the post. Bore anchor holes through each of the screw hole marks on the block fence.

how to hang a gate